Nissan Qashqai e-POWER 2023 Owners Manual
9.4.2.3. Removing the wheel
Make sure to read the caution label attached to the jack body before use.
DO NOT GET UNDER A VEHICLE THAT IS SUPPORTED BY A JACK.
Never use a jack which was not provided with your vehicle.
The jack, which is provided with your vehicle is designed only to lift your vehicle during a tyre change.
Use the correct jacking points. Never use any other part of the vehicle for jack support.
Never lift the vehicle more than necessary.
Never use blocks on or under the jack.
Do not start or run the e-POWER system while the vehicle is on the jack. The vehicle may move suddenly, and this may cause an accident.
Never allow passengers to stay in the vehicle while the tyre is off the ground.
Remove all loads before lifting the vehicle with the jack.
Place the jack directly under the jacking point as illustrated so that the top of the jack contacts the vehicle at the jacking point.
The jack should be placed on firm level ground.
Align the centre of both the jack head and the notches at the jacking point as shown.
Fit the groove of the jack head between the two notches as shown.
Alloy wheels (where fitted): Alloy wheel bolts have a plastic cap that can be removed using tweezers (where fitted) from the tool kit.
Loosen each wheel bolt by one or two turns anticlockwise with the wheel wrench.
Do not remove the wheel bolts until the tyre is off the ground.
To lift the vehicle, securely hold and turn the handle clockwise as shown.
Carefully raise the vehicle until the tyre clears the ground.
Remove the wheel bolts, then remove the wheel with the flat tyre.
The wheel is heavy. Be sure that your feet are clear of the wheel and use gloves as necessary to avoid injury.