Nissan X-Trail e-POWER 2023 Owners Manual
6.4.1.1. For models with ultrasonic sensor and tilt sensor (where fitted)
How to activate system
Close all windows and sunroof (where fitted).
Place the power switch in the “OFF” position.
Carry the Intelligent Key with you and get out of the vehicle.
Make sure the bonnet and the back door are closed. Close and lock all doors with the Intelligent Key, the lock sensor (on the front door handles) (where fitted) or the request switch (where fitted).
If the bonnet is open, the buzzer will sound. The buzzer will stop when the bonnet is correctly closed.
Even when the driver and/or passengers are in the vehicle, the system will activate with all doors locked and the power switch off. Place the power switch in the ON position to turn the system off.
If the system malfunctions, the short beep sounds 5 times when the system is activated. Have the system checked by a NISSAN dealer or qualified workshop.
Theft warning system operation
The warning system will give the following alarm:
The hazard indicator lights blink and the horn sounds intermittently for approximately 30 seconds.
The alarm automatically turns off after approximately 30 seconds. However, the alarm reactivates if the vehicle is tampered with again.
The alarm is activated when:
operating the door or the back door without using the Intelligent Key, the capacitive unlock sensor (on the front door handles) (where fitted) or the request switch (where fitted).
opening the bonnet (where fitted).
the volumetric sensing system (ultrasonic sensor) is triggered (when it is activated).
the power supply is disconnected.
the vehicle inclination is detected by the tilt sensor (when it is activated) (where fitted).
How to stop alarm
The alarm will stop by unlocking a door with the capacitive unlock sensor (where fitted), the request switch (where fitted) or the “UNLOCK”
button on the Intelligent Key.The alarm will stop if the power switch is placed in the ON position.
Operation of the ultrasonic sensor and tilt sensor (where fitted)
The ultrasonic sensor (volumetric sensing) detects movement in the passenger’s compartment. The tilt sensor (where fitted) detects the vehicle inclination. When the theft warning system is set to the armed position, it will automatically switch on the ultrasonic sensor and tilt sensor (where fitted).
It is possible to exclude the ultrasonic sensor and tilt sensor (where fitted)(for example, when transporting the vehicle on a ferry).
To exclude the ultrasonic sensor and tilt sensor (where fitted).:
Close all the windows.
Place the power switch in the “OFF” position.
Push the
button until “Settings” appears in the vehicle information display and then push the scroll dial. Use the scroll dial to select “Vehicle Settings”. Then push the scroll dial.Select “Alarm System”. Then push the scroll dial. The following options are available:
Always ON
When selected, the ultrasonic sensor and tilt sensor (where fitted) will activate each time the alarm is set.
Ask on Exit
When selected, the system provides the choice to disable the ultrasonic sensor and tilt sensor (where fitted) after the power switch is placed in the “OFF” position.
Disable Once
When selected, the ultrasonic sensor and tilt sensor (where fitted) will be disabled until the next time the theft warning system is disarmed.
Select “Disabled Once” or “Ask on Exit”. Then push the scroll dial.
Close the doors, bonnet and back door. Lock them using the Intelligent Key, the lock sensor (where fitted) or the request switch (where fitted).
The ultrasonic sensor and tilt sensor (where fitted) are now excluded from the theft warning system. All other functions of the system remain activated until the theft warning system is disarmed again.