Nissan X-Trail e-POWER 2023 Owners Manual
6.3.3.2. Locking doors
Push the P position switch to engage the “P” (Park) position. Place the power switch in the “OFF” position and make sure you carry the Intelligent Key with you.
Close all doors.
Touch the lock sensor (A) or push the back door request switch (C) while carrying the Intelligent Key with you.
All doors and the back door will lock. The hazard indicator lights flash once.
For models with the Super Lock system:
To activate the Super Lock system, lock the doors by double-pressing the lock sensor (A). The hazard indicator lights flash longer to indicate Super Lock system activation.
Lock sensors for all doors can be deactivated when the “I-Key Door Lock” is turned off in the Vehicle Setting of the vehicle information display. For additional information, see
.Doors lock with the lock sensor or back door request switch while the power switch is not in the “OFF” position
Doors do not lock by touching the driver’s door lock sensor while the driver's door is open. However, doors lock with the mechanical key even if any door is open.
Doors do not lock with the lock sensor or back door request switch with the Intelligent Key inside the vehicle and a beep sounds to warn you. However, when an Intelligent Key is inside the vehicle, doors can be locked with another Intelligent Key.
Doors do not lock with the lock sensor while the e-POWER system is running.
If the door handle becomes wet while the Intelligent Key is within the effective range, the door may lock and unlock repeatedly. In this case, follow the following correction procedures to wash the vehicle:
Place the Intelligent Key in a location 2 m (6 ft) or more away from the vehicle. (Take care to ensure that the key is not stolen.)
If the Intelligent Key is inside the vehicle and a door handle becomes wet during a car wash, a buzzer will sound outside the vehicle. To turn off the alarm, take the Intelligent Key from inside the vehicle.
The lock sensor may not work properly if it comes in contact with ice, snow, mud, etc. Clean the lock sensor and attempt to operate it again.
If the door handle becomes wet, such as rain, the door may delay or prevent lock operation. In this case, try to touch firmly the sensor for at least 1 second.
The lock sensor may not react immediately when the door handle gets wet from rain, etc. Keep touching the lock sensor until the doors lock, or touch the lock sensor after grasping the door handle.
After locking the doors using the lock sensor or back door request switch, make sure that the doors have been securely locked by operating the door handles or the back door opener switch.
When locking the doors using the lock sensor or back door request switch, make sure to have the Intelligent Key in your possession before operating the lock sensor or back door request switch to prevent the Intelligent Key from being left in the vehicle.
The lock sensor or back door request switch is operational only when the Intelligent Key has been detected by the Intelligent Key system.