Nissan X-Trail e-POWER 2023 Owners Manual

8.21.10.3. Operating conventional (fixed speed) cruise control mode

image

To turn on the conventional (fixed speed) cruise control mode, push and hold the ProPILOT Assist switch (A) for longer than about 1.5 seconds.

When pushing the ProPILOT Assist switch on, the conventional (fixed speed) cruise control mode display and indicators are displayed in the vehicle information display. After you hold the ProPILOT Assist switch on for longer than about 1.5 seconds, the ICC system display turns off. The cruise indicator appears. You can now set your desired cruising speed. Pushing the ProPILOT Assist switch again will turn the system completely off. When the power switch is placed in the “OFF” position, the system is also automatically turned off.

To use the ICC system again, quickly push and release the ProPILOT Assist switch (vehicle-to-vehicle distance control mode) or push and hold it (conventional cruise control mode) again to turn it on.

image

To avoid accidentally engaging cruise control, make sure to turn the ProPILOT Assist switch off when not using the ICC system.

image

To set cruising speed, accelerate your vehicle to the desired speed, push down the <SET–> (B) switch and release it. (The colour of the cruise indicator changes to green and vehicle set speed indicator comes on.) Take your foot off the accelerator pedal. Your vehicle will maintain the set speed.

  • To pass another vehicle, depress the accelerator pedal. When you release the pedal, the vehicle will return to the previously set speed.

  • The vehicle may not maintain the set speed when going up or down steep hills. If this happens, manually maintain vehicle speed.

To cancel the preset vehicle speed, use any of the following methods:

  • Push the <CANCEL> switch. The vehicle set speed indicator and the cruise indicator will turn grey.

  • Tap the brake pedal. The vehicle set speed indicator and the cruise indicator will turn grey.

  • Turn the ProPILOT Assist switch off. Both the cruise indicator and vehicle set speed indicator will turn off.

To reset at a faster cruising speed, use one of the following three methods:

  • Depress the accelerator pedal. When the vehicle attains the desired speed, push down and release the <SET-> switch.

  • Push up and hold the <RES+> switch. When the vehicle attains the desired speed, release the switch.

  • Push up, then quickly release the <RES+> switch. Each time you do this, the vehicle set speed will increase by about 1 km/h (1 MPH).

To reset at a slower cruising speed, use one of the following three methods:

  • Lightly tap the brake pedal. When the vehicle attains the desired speed, push down the <SET-> switch and release it.

  • Push down and hold the <SET-> switch. Release the switch when the vehicle slows down to the desired speed.

  • Push down, then quickly release the <SET-> switch. Each time you do this, the vehicle set speed will decrease by about 1 km/h (1 MPH).

To resume the preset vehicle speed, push up and release the <RES+> switch. The vehicle will resume the last set cruising speed when the vehicle speed is over 30 km/h (20 MPH).

Parent topic: