Nissan X-Trail e-POWER 2023 Owners Manual
5.19.1.5. When power window switch does not operate
If the power window automatic function does not operate properly, perform the following procedure to initialise the power window functions.
Close the door.
Place the power switch in the ON position.
Pull the power window switch and hold it to fully close the window.*1
Release the power window switch.
Pull the power window switch and hold it for approximately 5 seconds or more.*2
Push the power window switch down and hold it to fully open the window.
Release the power window switch.
Push the power window switch down and hold it for approximately 5 seconds or more.*2
Pull the power window switch and hold it to fully close the window.*1
Operate the window by the automatic function (window open and close) to confirm that the initialisation is complete.
*1: If the window stops before reaching the fully closed position, release the switch, then pull and hold it again to fully close the window.
*2: After pulling or pushing the power window switch and holding it for approximately 5 seconds or more, the window will move again.
If the window cannot automatically be closed since the auto-reverse function activated due to a malfunction, perform the following procedure to cancel the auto-reverse function.
Pull the power window switch up until the auto-reverse function is activated, then the window will reverse automatically.
Repeat the procedure twice.
Pull the power window switch and hold it to close the window to confirm that the cancellation is completed.
When the auto-reverse function is cancelled, the window will not automatically reverse even if the control unit detects an obstacle. Make sure that all passengers have their hands, etc. inside the vehicle before closing the windows.
If the power window functions do not operate properly after performing the procedure above, have your vehicle checked by a NISSAN dealer or qualified workshop.