Nissan ARIYA 2024 Owners Manual
4.3.1.2. How to start quick charge
Push the park button on the shift lever to place the vehicle in the P (Park) position, and apply the parking brake.
Place the power switch in the OFF position.
The charge port lid is linked to the door locking mechanism of the vehicle.
To open the charge port lid, unlock the doors (see
) and push the rear part of the lid as illustrated. Then open the charge port cap. (See .)Follow the instructions on the quick charge equipment, insert the charge connector all the way in.
Be sure to insert the charge connector straight into the quick charge port all the way in. Failure to do so may result in the Li-ion battery not charging or could cause damage to the charging equipment.
Follow the instructions on the quick charge equipment to start charging. When the equipment is properly installed and ready to charge, a beep sounds twice and the charging status indicator light will operate. See
.
Charging ends in the following situations:
When charging is complete.
When the possible charge time set for the quick charger is exceeded.
Charging may automatically stop even if it is not completed.
If charging stops mid-charge, you can restart charging by pushing the start button on the quick charger station again.
The charge connector is locked to the charge port after it is connected and cannot be disconnected. Follow the instructions on the quick charge equipment to stop charging. Confirm charging is stopped by looking at the charging status indicator light on the instrument panel. The charge connector can be disconnected from the vehicle when charging has stopped.
When quick charging, the Li-ion battery charging rate is slower as the percentage of available battery charge increases.
When quick charging, the Li-ion battery charging rate is slower when the Li-ion battery temperature is extremely high or low.