Nissan ARIYA 2024 Owners Manual
6.15.2.2. Operation of the wireless charger
To use the wireless charger, it is necessary to seat the smartphone well within the charging pad. To maximise charging performance, ensure the smartphone is fully seated on the centre of the charging pad over the "Qi" logo (A). Because the location of the power receiver may vary depending on the smartphone, you will need to try and find the area that suits your smartphone.
Because some smartphone cases or accessories may adversely affect charging, remove them before wireless charging.
Turn off the vibration function of the smartphone before wireless charging.
Only a Qi compatible smartphone can be used.
The smartphone or the wireless charger may be warmed during charging process and the charging may stop by the protection function of the smartphone or the wireless charger. This is not a malfunction. If this occurs, restart charging after the smartphone or the wireless charger cooled down. The indicator will blink in orange then turn off.
The wireless charging process may be stopped by the status of the smartphone (battery temperature, etc.).
If a radio noise interference occurs during charging process, put the smartphone onto the centre (“Qi” logo) position of the wireless charger.
The wireless charging process will stop during process of searching the Intelligent Key.
The wireless charging process will not be started when a USB (Universal Serial Bus) cable is connected to the smartphone. The indicator may illuminate in orange or blink if the smartphone is put on the wireless charger with a USB cable connected. However, charging is not performed.
Depending on the type of the smartphone, the indicator may remain illuminated in orange even when the charging process has been completed.