Nissan ARIYA 2024 Owners Manual
9.22.3. RAB system limitations
Listed below are the system limitations for the RAB system. Failure to follow the warnings and instructions for proper use of the RAB system could result in serious injury or death.
When the vehicle approaches an obstacle while the accelerator or brake pedal is depressed, the function may not operate or the start of the operation may be delayed. The RAB system may not operate or may not perform sufficiently due to vehicle conditions, driving conditions, the traffic environment, the weather, road surface conditions, etc. Do not wait for the system to operate. Operate the brake pedal by yourself as soon as necessary.
If it is necessary to override RAB operation, strongly press the accelerator pedal.
Always check your surroundings and turn to check what is behind you before and while reversing. The RAB system detects stationary objects behind the vehicle. The RAB system does not detect the following objects:
Moving objects
Low objects
Narrow objects
Wedge-shaped objects
Complex-shaped objects
Multiple object in close
Objects close to the bumper (less than approximately 30 cm (1 ft))
Objects that suddenly appear
Thin objects such as rope, wire, chain, etc.
The RAB system may not operate for pedestrians or animals.
The RAB system may not operate for the following obstacles:
Obstacles located high off the ground
Obstacles in a position offset from your vehicle
Obstacles, such as spongy materials or snow, that have soft outer surfaces and can easily absorb a sound wave
The RAB system may not operate in the following conditions:
There is rain, snow, ice, dirt, etc., attached to the parking sensors (sonar).
A loud sound is heard in the area around the vehicle.
The surface of the obstacle is diagonal to the rear of the vehicle.
The parking sensors (sonar) or the area around them are extremely hot or cold.
The RAB system may unintentionally operate in the following conditions:
There is overgrown grass in the area around the vehicle.
There is a structure (e.g., a wall, toll gate equipment, a narrow tunnel, a parking lot gate) near the side of the vehicle.
There are bumps, protrusions, or manhole covers on the road surface.
The vehicle is driving through a draped flag or a curtain.
The vehicle is approaching a high curb or car stop.
The vehicle is driving on a steep hill.
There is an accumulation of snow or ice behind the vehicle.
An ultrasonic wave source, such as another vehicle’s parking sensor (sonar), is near the vehicle.
Once the automatic brake control operates, it does not operate again if the vehicle approaches the same obstacle.
The automatic brake control can only operate for a short period of time. Therefore, the driver must depress the brake pedal.
In the following situations, the RAB system may not operate properly or may not function sufficiently:
The vehicle is driven in bad weather (rain, fog, snow, etc.).
The vehicle is driven on a steep hill.
The vehicle’s posture is changed (e.g., when driving over a bump).
The vehicle is driven on a slippery road.
The vehicle is turned sharply by turning the steering wheel fully.
Snow chains are used.
Wheels or tyres other than NISSAN recommended are used.
The brakes are cold at low ambient temperatures or immediately after driving has started.
The braking force becomes poor due to wet brakes after driving through a puddle or washing the vehicle.
Turn the RAB system off in the following conditions to prevent the occurrence of an unexpected activation resulting from sudden system operation:
The vehicle is towed.
The vehicle is carried on a flatbed truck.
The vehicle is on the chassis dynamometer.
The vehicle drives on an uneven road surface.
Suspension parts other than those designated as genuine parts are used. (If the vehicle height or the vehicle body inclination is changed, the system may not detect an obstacle correctly.)
If the vehicle is using an accessory like a bike rack, or cargo carrier that blocks the sensors.
When towing a trailer or other vehicle, turn the RAB system off to prevent the occurrence of an unexpected accident resulting from sudden system operation. (See
.)Excessive noise (e.g., audio system volume, an open vehicle window) will interfere with the chime sound, and it may not be heard.