Nissan ARIYA 2024 Owners Manual
8.5.7. Rear view monitor system limitations
Listed below are the system limitations for rear view monitor. Failure to operate the vehicle in accordance with these system limitations could result in serious injury or death.
The system cannot completely eliminate blind spots and may not show every object.
Underneath the bumper and the corner areas of the bumper cannot be viewed on the rear view monitor because of its monitoring range limitation. The system will not show small objects below the bumper, and may not show objects close to the bumper or on the ground.
Objects viewed in the rear view monitor differ from actual distance because a wide-angle lens is used.
Objects in the rear view monitor will appear visually opposite compared to when viewed in the rearview and outside mirrors.
Use the displayed lines as a reference. The lines are highly affected by the number of occupants, vehicle position, road conditions and road grade.
Make sure that the liftgate is securely closed when reversing.
Do not put anything on the rear view camera. The rear view camera is installed above the number plate.
When washing the vehicle with high-pressure water, be sure not to spray it around the camera. Otherwise, water may enter the camera unit causing water condensation on the lens, a malfunction, fire or an electric shock.
Do not strike the camera. It is a precision instrument. Otherwise, it may malfunction or cause damage resulting in a fire or an electric shock.
The following are operating limitations and do not represent a system malfunction:
When the temperature is extremely high or low, the screen may not clearly display objects.
When strong light directly shines on the camera, objects may not be displayed clearly.
Vertical lines may be seen in objects on the screen. This is due to strong reflected light from the bumper.
The screen may flicker under fluorescent light.
The colours of objects on the rear view monitor may differ somewhat from the actual colour of objects.
Objects on the monitor may not be clear in a dark environment.
There may be a delay when switching between views.
If dirt, rain or snow accumulates on the camera, the rear view monitor may not display objects clearly. Clean the camera.
Do not use wax on the camera lens. Wipe off any wax with a clean cloth dampened with a diluted mild cleaning agent, then wipe with a dry cloth.