Nissan ARIYA 2024 Owners Manual
6.15.2.2. Operation of the wireless charger
To use the wireless charger, it is necessary to properly position the smartphone on the charging pad with the screen facing up. To maximise charging performance, ensure the smartphone is fully seated on the centre of the charging pad over the "Qi" logo (A). Because the location of the power receiver may vary depending on the smartphone, you will need to try and find the area that suits your smartphone.
Remove the smartphone case or accessories before charging, as they may affect charging capability.
Only a Qi compatible smartphone can be used.
The charging may not be possible depending on the smartphone type. Please refer to your smartphone's instruction manual for details.
Smartphones that are too large to be placed on the charging pad cannot be charged.
Smartphones that are smaller than 139 x 69 mm (5.5 x 2.7 in) may not be charged. If a smartphone smaller than the above size is placed in a corner and cannot be charged, reposition the smartphone to the centre of the charging pad.
Never put a magnetic card between the charging pad and a smartphone. Also, never put a credit card, magnetic recording medium, etc. near the charging pad. The recorded data may be damaged.
The charging pad can be used as a storage space while a Qi compatible smartphone is not placed.
If the smartphone moves out of the charging pad, place the smartphone back on the "Qi" logo.
Turn off the vibration function of the smartphone before wireless charging.
If you charge your smartphone while using apps or immediately after using apps, the smartphone or the wireless charger may be warmed during charging process and the charging may stop by the protection function of the smartphone or the wireless charger. This is not a malfunction. If this occurs, restart charging after the smartphone or the wireless charger cooled down. The indicator will blink in orange then turn off.
The wireless charging process may be stopped by the status of the smartphone (battery temperature, etc.).
If a radio noise interference occurs during charging process, put the smartphone onto the centre (
logo) position of the wireless charger again.The wireless charging process will stop during process of searching the Intelligent Key.
The wireless charging process will not be started when a USB (Universal Serial Bus) cable is connected to the smartphone. The indicator may illuminate in orange or blink if the smartphone is put on the wireless charger with a USB cable connected. However, charging is not performed.
Depending on the type of the smartphone, the indicator may remain illuminated in orange even when the charging process has been completed.
When putting only metallic materials or key (Intelligent Key) on the charging pad, the indicator may illuminate for a short period of time. The wireless charging process is not operated.