Nissan Juke 2022-present Owners Manual

Dynamic Dynamic high beam assistant (where fitted)

image

A camera-controlled high beam assistant which changes from low beam to high beam automatically.

Precautions

image

The dynamic high beam assistant cannot compensate for road and weather circumstances while driving. The system saves the driver from having to operate the switch. The driver always remains responsible for choosing the correct light setting.

Specific situations in which to operate the headlight switch manually:

  • In heavy rain, snowy conditions. (general poor visibility and bad weather conditions).

  • When the vehicle sensors are dirty, covered or broken.

Dynamic high beam assistant activated

When the headlight switch is in the <AUTO> position, the light sensor detects darkness, and the lever is pushed forward (into high beam position), the dynamic high beam assistant is operational. The dynamic high beam assistant indicator light image in the instrument panel is on.

The system operates as follows:

  • High beam comes on automatically in dark conditions:

    If the vehicle speed is over 40 km/h (25 MPH) and no other road users are recognised.

    The image high beam light (blue) comes on additionally.

  • High beam turns off automatically:

    If the vehicle speed drops below 25 km/h (15 MPH) or other road users are detected.

    The image High beam light (blue) turns off.

image

If the dynamic high beam assistant cannot function (for example: up to 15 seconds after start up, snow covering front camera or similar) the headlights will operate as if the switch was in the manual position. At all times, the status of the dynamic high beam assistant status system is shown by the indicator lights in the instrument panel. Full dynamic high beam assistant operation is shown by the image indicator light. If the system cannot function, only the image high beam indicator light and/or image dipped beam indicator light is illuminated, depending on the current switch position.

To disable the dynamic high beam assistant

To turn the dynamic high beam assistant off turn the headlight switch to the image, or image position.

Parent topic: