Nissan Juke 2022-present Owners Manual
Steering Steering Assist Activation/Deactivation
Use the following methods to enable or disable the Steering Assist.
ProPILOT switch on steering wheel
Press the ProPILOT switch. This will turn ICC and Steering Assist on in standby mode and Steering Assist icons will appear in grey. Note that Steering Assist may already be switched on, depending on the settings in the [Settings] menu. These settings are retained if the engine is restarted.
Then press <SET> on the right-hand steering wheel switch to set cruise control speed. When the system detects clear lane markings the Steering Assist icons will turn green and the Steering Assist system will become active.
The Steering Assist icon will remain grey if the vehicle is driven at speeds under 60 km/h (37 MPH) and no vehicle ahead is detected
Steering Assist switch
To turn the Steering Assist ON or OFF, push the Steering Assist switch on the instrument panel.
When the Steering Assist switch is used to turn the system ON or OFF, the system remembers the setting when the engine is restarted. The switch must be pushed again to change the setting to ON or OFF.
The Steering Assist switch changes the status of the [Steering Assist] selection made in the [Settings] screen in the Vehicle Information Display.
Setting in the Vehicle Information Display
Press the
or 
buttons on the left hand side of the steering wheel until the [Settings] menu is displayed in the Vehicle Information Display and press the <OK> button.Use the
and 
buttons on the steering wheel to highlight [Driver Assistance] and press the <OK> button.With [Steering Assist] highlighted press the <OK> button to toggle the Steering Assist system status.
An indicator indicates that Steering Assist is selected.
When the Steering Assist screen is displayed on the Vehicle Information Display, press the <OK> button on the steering wheel to show the [Driver Assistance] setting menu.
When enabling/disabling the system through the Vehicle Information Display or when pressing the Steering Assist switch, the system retains the current settings even if the engine is restarted.