Nissan Juke 2024 Owners Manual
7.14.1. Normal operation
The Stop/Start System has stopped the engine and will automatically restart the engine. The Stop/Start symbol is shown in the vehicle information display.
The Stop/Start System will not activate under the following conditions:
When the engine is kept idling without any driving after the engine is turned on.
When the engine coolant temperature is low.
When the battery capacity is low.
When the battery temperature is low or extremely high.
When the vehicle is moved.
When the vacuum in the brake servo decreases.
When the engine bonnet is opened with the engine running.
When the engine is turned on with the engine bonnet open.
When the driver’s seat belt is not fastened.
When the driver’s door is open.
When the steering wheel is operated.
When the Stop/Start System indicator blinks at a low speed.
When the accelerator pedal is depressed (Automatic (DCT) transmission models).
When the shift lever is in the R (Reverse) position.
When the fan speed control dial is in any position other than OFF (0) while the air flow control dial is in the front defogger position (manual air conditioner).
When the front defogger switch is on (automatic air conditioner).
When the Stop/Start System OFF switch is turned on.
When the electric power steering warning light, the Anti-lock Braking System (ABS) warning light, or the Electronic Stability Programme (ESP) warning light illuminates.
When Intelligent Key is not detected for DCT or MT.
When the brake pedal is not fully depressed (Automatic (DCT) transmission models).
When stopping the vehicle on steep sloping roads (Automatic (DCT) transmission models).
When the power consumption is high.
When the vehicle is travelling at altitudes higher than 2000 m (6562 ft) (MT models).
It may take some time until the Stop/Start System activates under the following conditions:
When the battery is discharged.
When the outside temperature is low.
When the battery is replaced or the battery terminal is disconnected for extended periods and then reconnected.
The engine will not restart even if the brake pedal is released (Automatic (DCT) transmission ) or clutch pedal is pressed (MT) while the Stop/Start System is activated under the following condition:
When the shift lever is in the P (Park) position (Automatic (DCT) transmission models).
When the engine bonnet is opened.
When the driver seat belt is unfastened and the driver's door is opened (MT models).
When the shift lever is not in the (N) Neutral position (MT models).
When the shift lever is in the (N) Neutral position and the parking brake is on (Automatic (DCT) transmission models).
When the Automatic brake hold indicator (green) (where fitted) is illuminated (Automatic (DCT) transmission models)
The engine will restart without releasing the brake pedal (Automatic (DCT) transmission models) or without depressing the clutch pedal (MT models) while the Stop/Start System is activated under the following conditions:
When the Stop/Start System OFF switch is pushed.
When the fan speed control dial is in any position other than OFF (0) while the air flow control dial is in the front defogger position (manual air conditioner).
When the front defogger switch is set to ON (automatic air conditioner).
When the accelerator pedal is depressed. (Automatic (DCT) transmission models)
When the steering wheel is operated. (Automatic (DCT) transmission models)
When the battery capacity is low.
When the power consumption is high.
When the brake pedal is released on sloping roads and the vehicle is moved.
When the force to the brake pedal is reduced while the shift lever is in the D (Drive) or N (Neutral) position. (Automatic (DCT) transmission models)
When the shift lever is placed in the R (Reverse) position from the N (Neutral) or P (Park) position (Automatic (DCT) transmission models). If D (Drive) is selected from P (Park) or N (Neutral) during a Stop/Start system stop in an Automatic (DCT) vehicle, the engine will not restart until the brake pedal is released.
When the paddle shift is operated (where fitted) (Automatic (DCT) transmission models)
When the Intelligent Key is not detected for DCT or MT.
When the vacuum of the brake servo is insufficient as a result of depressing the brake pedal several times.
When the driver's seat belt is released or the driver's door is open. (Automatic (DCT) transmission models) (Manual transmission models if gear is not engaged).
Use this system while waiting at traffic lights, etc. When the vehicle is stopped for long periods of time, turn off the engine.
When the engine bonnet is opened with the Stop/Start System on, the engine will be in the normal stopped state with the buzzer sounding. In this case, restart the engine with the ignition switch.
When the engine is stopped by the Stop/Start System, heating, cooling and dehumidifying functions will be deactivated. To avoid the air conditioning functions from being deactivated, turn off the Stop/Start System by pressing the Stop/Start System OFF switch.
The Stop/Start System is always engaged at the start of a journey (once the engine has been started). The engine is automatically stopped and restarted during the journey if conditions are suitable
When the engine is stopped the following information is displayed for a few seconds.
See
for information about the display.
| Automatic engine restart is possible whenever the Stop/Start System symbol is illuminated at the bottom of the display. |
Whilst the engine remains stopped the vehicle information display shows the accumulated quantity (estimate) of carbon dioxide exhaust emissions (where fitted) prevented by the Stop/Start System.
| The [CO2 Saved] can be reset in the [Settings] menu; see . |
When automatic restart is not possible the following information is displayed. The engine must be started using the ignition switch.
| The message can be cleared by pressing the steering wheel <OK> button, restarting the engine, or placing the ignition in the OFF position. |
