Nissan Juke 2024 Owners Manual
7.20.7.3. Operating conventional (fixed speed) cruise control mode (manual transmission vehicles)
To turn the conventional (fixed speed) cruise control mode on, push and hold the Drive Assist switch for longer than about 1.5 seconds.
When pushing the Drive Assist switch on, the ICC system display and indicators are displayed in the vehicle information display. After you hold the Drive Assist switch for longer than about 1.5 seconds, the ICC system display goes out. The cruise indicator appears. You can now set your desired cruising speed. Pushing the Drive Assist switch again will turn the system completely off.
When the power switch is placed in the OFF position, the system is also automatically turned off.
To use the ICC system again, quickly push and release the Drive Assist switch (vehicle-to-vehicle distance control mode) or push and hold it (conventional cruise control mode) again to turn it on.
To avoid accidentally engaging cruise control, make sure to turn the Drive Assist switch off when not using the ICC system.
To set cruising speed, accelerate your vehicle to the desired speed, push the <SET/-> switch and release it. (The colour of the cruise indicator changes to green and the set vehicle speed indicator comes on.) Take your foot off the accelerator pedal. Your vehicle will maintain the set speed.
To pass another vehicle, depress the accelerator pedal. When you release the pedal, the vehicle will return to the previously set speed.
The vehicle may not maintain the set speed when going up or down steep hills. If this happens, manually maintain vehicle speed.
To cancel the preset speed, use any of the following methods:
Push the CANCEL switch . The vehicle speed indicator will turn grey.
Tap the brake pedal. The vehicle speed indicator will turn grey.
To reset at a faster cruising speed, use one of the following three methods:
Depress the accelerator pedal. When the vehicle attains the desired speed, push and release the <SET/-> switch.
Push and hold the <RES/+> switch. When the vehicle displays the desired set speed, release the switch.
Push, then quickly release the <RES/+> switch. Each time you do this, the set speed will increase by about 1 km/h (1 MPH).
To reset at a slower cruising speed, use one of the following three methods:
Lightly tap the brake pedal. When the vehicle attains the desired speed, push the <SET/-> switch and release it.
Push and hold the <SET/-> switch. Release the switch when the vehicle slows down to the desired speed.
Push, then quickly release the <SET/-> switch. Each time you do this, the set speed will decrease by about 1 km/h (1 MPH).
To resume the preset speed, push and release the <RES/+> switch. The vehicle will resume the last set cruising speed when the vehicle speed is over 30 km/h (20 MPH).