Nissan Juke 2024 Owners Manual
8.5.2.4. Removing the wheel
Make sure to read the caution label attached to the jack body before use.
DO NOT GET UNDER A VEHICLE THAT IS SUPPORTED BY A JACK.
Never use a jack which was not provided with your vehicle.
The jack, which is provided with your vehicle is designed only to lift your vehicle during a tyre change.
Use the correct jacking points. Never use any other part of the vehicle for jack support.
Never lift the vehicle more than necessary.
Never use blocks on or under the jack.
Do not start the hybrid system while the vehicle is on the jack. The vehicle may move suddenly, and this may cause an accident.
Never allow passengers to stay in the vehicle while the tyre is off the ground.
Make sure to read the caution label attached to the jack body before use.
Remove all loads before lifting the vehicle with the jack.
- Place the jack directly under the jack-up point as illustrated so that the top of the jack contacts the vehicle at the jack-up point.
The jack should be placed on firm level ground.
- Align the centre of both the jack head and the notches at the jack-up point as shown.
- Fit the groove of the jack head between the two notches as shown.
Alloy wheels (where fitted): Alloy wheel bolts have a plastic cap that can be removed using tweezers (where fitted) from the tool kit.
- Loosen each wheel bolt by one or two turns anticlockwise with the wheel wrench.
- Do not remove the wheel bolts until the tyre is off the ground.
- Models with wheel lock bolts (where fitted) :
- If the wheel is equipped with a wheel lock bolt, insert the wheel lock key (1) and loosen it as previously described.
- The wheel lock bolt can only be removed with the wheel lock key. A key number is necessary if you need to duplicate the wheel lock key.
- Record the key number as shown on the key code card on the “Security information” page at the end of this manual and keep it in a safe place, not in the vehicle. If you lose the wheel lock key, see your NISSAN dealer for a duplicate with the original wheel lock key code.
- Make sure to keep the lock key in the vehicle. Otherwise, wheels cannot be removed and the service cannot be performed.
- To lift the vehicle, securely hold and turn the handle clockwise as shown.
- Carefully raise the vehicle until the tyre clears the ground.
- Remove the wheel bolts, then remove the wheel with the flat tyre.
The wheel is heavy. Be sure that your feet are clear of the wheel and use gloves as necessary to avoid injury.