Nissan Juke 2024 Owners Manual
7.15.6. System maintenance
The two radar sensors (A) for the BSW/Intelligent Blind Spot Intervention system are located near the rear bumper.
To keep the BSW/Intelligent Blind Spot Intervention system operating properly, be sure to observe the following:
Always keep the area near the radar sensors clean.
The radar sensors may be blocked by temporary ambient conditions such as splashing water, mist, or fog.
The blocked condition may also be caused by objects such as ice, frost, or dirt obstructing the radar sensors. Check for and remove objects obstructing the area around the radar sensors.
Do not attach stickers (including transparent material), install accessories, or apply additional paint near the radar sensors
Do not attach metallic objects near the sensor area (brush guard, etc.). This could cause failure or malfunction.
Do not strike or damage the area around the radar sensors. If the area around the radar sensors is damaged due to an accident, it is recommended that you visit a NISSAN dealer or qualified workshop.
The lane camera unit (1) for the Intelligent Blind Spot Intervention system is located above the interior rear view mirror. To maintain the proper operation of the Intelligent Blind Spot Intervention system and prevent a system malfunction, be sure to observe the following:
Always keep the windscreen clean.
Do not attach a sticker (including transparent material) or install an accessory near the camera unit.
Do not place reflective materials, such as white paper or a mirror, on the instrument panel. The reflection of sunlight may adversely affect the camera unit's detection capability.
Do not strike or damage the areas around the camera unit. Do not touch the camera lens or remove the screw located on the camera unit. If the camera unit is damaged due to an accident, contact a NISSAN dealer or qualified workshop.