Nissan Juke 2024 Owners Manual
4.4.1.2. Washer operation
Pull the lever towards you (5) to operate the washer.
Wiper drip wipe system (where fitted)
The wiper will also operate once about 3 seconds after using the washer. This operation is to wipe washer fluid that has dripped on the windscreen.
Pulling up the wiper arms
The wiper arms should be in the service (up) position when replacing the wiper blades.
To pull the wiper arms up to the service position: within 1 minute of placing the ignition switch in the OFF position, push the lever up (4) twice in quick succession. The wiper operation stops in mid-operation. The wiper arms can then be pulled up to the service position.
To return the wiper arms to their normal position, place the wiper arms in the down position and then push the lever (4) up once.
For more information on replacing the windscreen wiper blades, see
.
This function can be operated even if the ignition switch is in the ON position. However, to prevent an accident or damage when pulling up the wiper arms, be sure to observe the following precautions.
Make sure the shift lever is in the P (Park) position (Automatic (DCT) Transmission models).
Make sure the shift lever is in the N (Neutral) position, with the parking brake fully applied (Manual Transmission models).
Never allow the passengers to operate the windscreen wiper switch inadvertently.
Do not operate the windscreen wiper while the wiper arms are pulled up. The wiper arms may be damaged.