Nissan Qashqai 2024 Owners Manual
7.27.5. Operating the ProPILOT Assist system
- Distance switch:
- Changes the vehicle's following distance:
- Long → Middle → Short → Long
- <RES+> switch:
- Resumes set speed or increases speed incrementally.
- <CANCEL> switch:
- Deactivates the system without erasing the set speed.
- <SET–> switch:
- Sets desired cruise speed, reduces speed incrementally.
- ProPILOT Assist switch:
- Master switch to activate the system.
Push the ProPILOT Assist switch (5). This turns on the ProPILOT Assist system and displays the status of the ProPILOT Assist system on the Vehicle Information Display.
Accelerate or decelerate your vehicle to the desired speed.
Push the <SET-> switch. The ProPILOT Assist system begins to automatically maintain the set speed. The ProPILOT Assist [CRUISE] indicator and ProPILOT Assist indicators illuminate (blue), speed control status indicator and set speed illuminate green.
When a vehicle ahead is travelling at a speed of 30 km/h (20 MPH) or below and the <SET-> switch is pushed, the set speed of your vehicle is 30 km/h (20 MPH).
Turning the ProPILOT Assist system on will turn on the Emergency Lane Assist (ELA) system. For additional information, refer to
.When the <SET-> switch is pushed under the following conditions, the ProPILOT Assist system cannot be set and the set vehicle speed indicators blinks for approximately 2 seconds:
When travelling below 30 km/h (20 MPH) and the vehicle ahead is not detected.
When the transmission is not in the D (Drive) position or Manual mode.
When the parking brake is applied.
When the brakes are operated by the driver.
When the ESP system is off. For additional information about the ESP system, see
.When ESP (including the traction control system) is operating.
When [SNOW] mode or [OFF-ROAD] mode is selected (4WD models).
When a wheel is slipping.
When any door is open.
When the driver’s seat belt is not fastened.