11.7.2.1. Engine oil replacement

Park the vehicle on a level surface and apply the parking brake.

Start the engine. If the engine is cold, start and let the engine idle until the engine temperature reaches the operational temperature (approximately 5 minutes).

Turn the engine off.

Wait at least 15 minutes to let the engine oil drain back into the oil pan.

Remove the underbody cover (where fitted).

Place a large drain pan under the drain plug.

Remove the drain plug with a wrench.

Remove the oil filler cap and completely drain the oil.

If the engine oil filter needs to be changed, remove and replace it at this time. See

Clean and re-install the drain plug along with a new washer. Securely tighten the drain plug with a wrench. Do not use excessive force.

Refill the engine with recommended engine oil and quantity. (See

When filling the engine oil, do not remove the dipstick.

Install the engine oil filler cap securely.

Start the engine.

Check for any leakage around the drain plug. Correct as required.

Check the oil level with the dipstick. For details, see