Manuals

Nissan Qashqai e-POWER 2023 Owners Manual

8.20. Intelligent Cruise Control (ICC) (where fitted)

image

If your vehicle is fitted with ProPILOT Assist, refer to the dedicated section later in this manual for information on the Intelligent Cruise Control (ICC) System.

image

Failure to follow the warnings and instructions for proper use of the ICC system could result in serious injury or death.

  • ICC is not a collision avoidance or warning device. It is intended for motorway use only and it is not intended for congested areas or city driving. Failure to apply the brakes could result in an accident.

  • The ICC system is only an aid to assist the driver and is not a collision warning or avoidance device. It is the driver's responsibility to stay alert, drive safely, and be in control of the vehicle at all times.

  • Always observe the posted speed limits and do not set the speed over them.

  • Always drive carefully and attentively when using either cruise control mode. Read and understand the Owner's Manual thoroughly before using the cruise control. To avoid serious injury or death, do not rely on the system to prevent accidents or to control the vehicle's speed in emergency situations. Do not use cruise control except in appropriate road and traffic conditions.

  • In the conventional (fixed speed) cruise control mode, a warning chime will not sound to warn you if you are too close to the vehicle ahead. Pay special attention to the distance between your vehicle and the vehicle ahead of you or a collision could occur.

The ICC system will maintain a constant set speed or keep a set distance from the vehicle in front of you up to the preset speed.

The vehicle travels at the set speed when the road ahead is clear.

The ICC system can be set to one of two cruise control modes.

  • Vehicle-to-vehicle distance control mode:

    For maintaining a selected distance between your vehicle and the vehicle in front of you up to the preset speed.

  • Conventional (fixed speed) cruise control mode:

    For cruising at a preset speed.

The ICC system cannot be operated when the speed limiter is on, see

Speed limiter (where fitted)
for additional information.
image
  • Distance switch:
  • Changes the vehicle's following distance:
  • Long → Middle → Short → Long
  • <RES+> switch:
  • Resumes set speed or increases speed incrementally.
  • <CANCEL> switch:
  • Deactivates the system without erasing the set speed.
  • <SET–> switch:
  • Sets desired cruise speed, reduces speed incrementally.
  • ICC ON/OFF switch:
  • Master switch to activate the system.
Parent topic:
Starting and driving