Nissan X-Trail e-POWER 2023 Owners Manual

8.21.5. Operating ProPILOT Assist

image
  1. Push the ProPILOT Assist switch (A). This turns on the ProPILOT Assist system.

    • The ProPILOT Assist status indicator (B) illuminates in white.

    • A screen is displayed for a period of time that indicates the status of the Driving Aid functions.

    image

    When the Driving Aids are enabled:

    Zone

    Driving Aid

    Forward

    Intelligent Emergency Braking with Pedestrian Detection

    Intelligent Forward Collision Warning

    Lane

    Lane Departure Warning (LDW)

    Intelligent Lane Intervention

    Blind Spot

    Blind Spot Warning (BSW)

    Intelligent Blind Spot Intervention (where fitted)

    • When any of the [Warning] systems are enabled, the “image” mark is shown in each zone.

    • When any of the [Intervention] systems are enabled, the “image” mark is shown in each zone.

    • When no system is enabled, [OFF] is shown in each zone.

    image

    To change the status of the Driving Aids, use (1) or (2) to navigate the settings screen. For additional information, see

    .
  2. Accelerate or decelerate your vehicle to the desired speed and push down the <SET-> switch (C).

    The ProPILOT Assist system begins to automatically maintain the vehicle set speed. The ProPILOT Assist activation indicator (D) and ProPILOT Assist status indicator (B) illuminate in blue. When a vehicle ahead is detected and travelling at a speed of 30 km/h (20 MPH) or below and the <SET-> switch is pushed down, the vehicle set speed is 30 km/h (20 MPH).

image

When the Intelligent Lane Intervention system and Intelligent Blind Spot Intervention system (where fitted) are enabled in the settings menu of the vehicle information display, turning the ProPILOT Assist system on will turn on these systems at the same time. If the Intelligent Lane Intervention system is disabled In the settings menu, the Intelligent Lane Intervention system will automatically be turned on when the Steering Assist system is active. For additional information, see

, and .
image

When the SET- switch is pushed down under the following conditions, the ProPILOT Assist system cannot be set and the vehicle set speed indicator (1) blinks for approximately 2 seconds:

  • When travelling below 30 km/h (20 MPH) and a vehicle ahead is not detected

  • When the shift lever is moved out of the D (Drive) position

  • When the parking brake is applied

  • When the brakes are operated by the driver

  • When ProPILOT Park (where fitted) is activated

  • When the ESP system is off. For additional information, see

    .
  • When the ESP system (including the traction control system) is activated

  • When the SNOW mode or OFF-ROAD mode is selected (4WD models)

  • When a wheel is slipping

  • When any door is open

  • When the driver’s seat belt is not fastened

Parent topic: