Nissan X-Trail e-POWER 2024 Owners Manual
8.17.1. Setting cruising speed
Accelerate to the desired speed.
Push down the <CANCEL> switch to SET- or push up the ${1} switch to RES+ and release it.
Take your foot off the accelerator pedal.
The vehicle will maintain the set speed. ([+ /- Change Set Speed] message appears in the display.)
If pushed up the <CANCEL> switch to RES+ and released it when there is no vehicle set speed, the set speed is set to the current vehicle speed.
Passing another vehicle
Depress the accelerator pedal to accelerate. After releasing the accelerator pedal, the vehicle will return to the previously set speed.
The vehicle may not maintain the set speed when going up or down steep hills. In such cases, drive without the cruise control.
Resetting to slower speed
Use any one of the following methods to reset to a slower speed.
Lightly tap the footbrake pedal. When the vehicle reaches the desired speed, push down the <CANCEL> switch to SET- and release it.
Push down and hold the <CANCEL> switch to SET-. This will reduce the vehicle speed by about 1 km/h or 1 MPH, or 5 km/h or 5 MPH depending on the model. When the vehicle reaches the desired speed, release the ${1} switch.
Quickly push down the <CANCEL> switch to SET- and release it. This will reduce the vehicle speed by about 1 km/h or 1 MPH.
Resetting to faster speed
Use any one of the following methods to reset to a faster speed.
Depress the accelerator pedal. When the vehicle reaches the desired speed, push down the <CANCEL> switch to SET- and release it.
Push up and hold the <CANCEL> switch to RES+. This will increase the vehicle speed by about 5 km/h or 5 MPH. When the vehicle reaches the desired speed, release the ${1} switch.
Quickly push up the <CANCEL> switch to RES+ and release it. This will increase the vehicle speed by about 1 km/h or 1 MPH.
Resuming at preset speed
Push up the <CANCEL> switch to RES+ and release it.
The vehicle will resume the last set cruising speed when the vehicle speed is over 30 km/h (20 MPH). ([Resumed] message appears in the display.)