Nissan ARIYA 2024 Owners Manual
9.16.2.2. Setting cruising speed
Accelerate to the desired speed.
Push the CANCEL switch to the SET- direction or RES+ direction and release it.
Take your foot off the accelerator pedal.
The vehicle will maintain the set speed. ([+ /- Change Set Speed] message appears in the display.)
If the CANCEL switch is pushed to the RES+ direction and released it when there is no vehicle set speed, the set speed is set to the current vehicle speed.
Passing another vehicle
Depress the accelerator pedal to accelerate. After releasing the accelerator pedal, the vehicle will return to the previously set speed.
The vehicle may not maintain the set speed when going up or down steep hills. In such cases, drive without the cruise control.
Resetting to slower speed
Use any one of the following methods to reset to a slower speed.
Lightly tap the footbrake pedal. When the vehicle reaches the desired speed, push and release the CANCEL switch to the SET- direction.
Push and hold the CANCEL switch to the SET- direction. This will reduce the vehicle speed by about 5 km/h or 5 MPH. When the vehicle reaches the desired speed, release the CANCEL switch.
Quickly push and release the CANCEL switch to the SET- direction. This will reduce the vehicle speed by about 1 km/h or 1 MPH.
Resetting to faster speed
Use any one of the following methods to reset to a faster speed.
Depress the accelerator pedal. When the vehicle reaches the desired speed, push and release the CANCEL switch to the SET- direction.
Push and hold the CANCEL switch to the RES+ direction. This will increase the vehicle speed by about 5 km/h or 5 MPH. When the vehicle reaches the desired speed, release the CANCEL switch.
Quickly push and release the CANCEL switch to the RES+ direction. This will increase the vehicle speed by about 1 km/h or 1 MPH.
Resuming at preset speed
Push and release the CANCEL switch to the RES + direction.
The vehicle will resume the last set cruising speed when the vehicle speed is over 30 km/h (20 MPH). ([Resumed] message appears in the display.)