Nissan Juke 2024 Owners Manual
3.6.6.1. Installation on rear seats
Front-facing
Be sure to follow the manufacturer’s instructions for the proper use of your child restraint. Follow these steps to install a front-facing child restraint on the rear seats using 3-point type seat belt without automatic locking mode:
Position the child restraint on the seat (1). If any contact occurs between the child restraint and the front seat, slide the front seat forward until contact no longer occurs.
Route the seat belt tongue through the child restraint and insert it into the buckle (2) until you hear and feel the latch engage.
To prevent slack in the seat belt webbing, it is necessary to secure the seat belt in place with locking devices attached to the child restraint.
Remove any additional slack from the seat belt; press downward (3) and rearward (4) firmly in the centre of the child restraint with your knee to compress the vehicle seat cushion and seatback while pulling up on the seat belt.
If the child restraint is equipped with a top tether strap, route the top tether strap and secure the tether strap to the tether anchor point. (See
.)
Test the child restraint before you place the child in it (5). Push the child restraint from side to side and tug it forward to make sure that it is held securely in place.
Check to make sure that the child restraint is properly secured prior to each use. If the child restraint is loose, repeat steps 3 through 5.
Rear-facing
Be sure to follow the manufacturer’s instructions for the proper use of your child restraint. Follow these steps to install a rear-facing child restraint on the rear seats using 3-point type seat belt without automatic locking mode:
Position the child restraint on the seat (1).
Route the seat belt tongue through the child restraint and insert it into the buckle (2) until you hear and feel the latch engage.
To prevent slack in the seat belt webbing, it is necessary to secure the seat belt in place with locking devices attached to the child restraint.
Remove any additional slack from the seat belt; press downward (3) and rearward (4) firmly in the centre of the child restraint with your hand to compress the vehicle seat cushion and seatback while pulling up on the seat belt.
Test the child restraint before you place the child in it (5). Push the child restraint from side to side and tug it forward to make sure that it is held securely in place.
Check to make sure that the child restraint is properly secured prior to each use. If the child restraint is loose, repeat steps 3 through 5.